Done something to my config, now all tools are gone.
-
Hi,
OK so still no tools?
Off topic but thought I would mention it.
I would update to firmware 2.04.
Regards M208: There is a "short form" now M208 Xmin:max keeping all the values together in one command.
Regards the M565/G10 "pairs": You can use just one G10 command with both sets of parameters. Again keeping things together.
Still haven't seen the problem. Will keep looking unless you find it first.
Frederick
-
Nope still no tools.
-
@cdl1701yahoo-com said in Done something to my config, now all tools are gone.:
Nope still no tools.
OK I will have to look again.
Frederick
-
Upgraded Firmware to 2.04.
Just an FYI, still no tools -
@cdl1701yahoo-com said in Done something to my config, now all tools are gone.:
Upgraded Firmware to 2.04.
Just an FYI, still no toolsWell we are missing something obvious.
Frederick
-
Hi,
I think the problem is the drive numbers in the M563 command.
I just checked my config and even though T0 is drive 3 in the M584 it is drive 0 in the M563.
I think that drive numbers in M563 start at 0 for the first extruder regardless of the drive number in M584.
Try that.
Frederick
-
Well that got my tools back but this is how it looks on my duet panel.
If I change the H parameter to use 1 & 2 then 3 & 4 go away but still shows 2000 temp reading which is obviously wrong! haha
-
Hi,
I don't think the heaters change numbers.
If memory serves they are always 0,1,2 on the Duet WiFi and 3,4,5,6,7 on the Duex5.
I have a duet panel but I have never used it.
Frederick
-
Any Idea how to get 3 & 4 to show as 1 & 2?
-
@cdl1701yahoo-com said in Done something to my config, now all tools are gone.:
Any Idea how to get 3 & 4 to show as 1 & 2?
No I don't. Someone should.
I never used my panel - it was just easier to use the web interface.
Frederick
