Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    New Magnetic filament sensor bad?

    Scheduled Pinned Locked Moved
    Filament Monitor
    2
    3
    150
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • warpsterundefined
      warpster
      last edited by

      Duet Magnetic Filament sensor...Nothing happens at power on. No LEDs nothing. Is the connector wired inside pin (toward 2 pin connector) to ground, middle pin to 3.3v and outside pin is the output. If so then not much else I can do, it is dead.

      Could someone validate the wiring for me? If I have it wired wrong then the docs are wrong....

      1 Reply Last reply Reply Quote 0
      • T3P3Tonyundefined
        T3P3Tony administrators
        last edited by

        sorry the documentation was confusing. I have updated it
        https://duet3d.dozuki.com/Wiki/Duet3dFilamentMonitor_RotatingMagnetVersion#Section_Wiring

        The original image was from the "top" side of the PCB wich is not the side the headers are on.

        www.duet3d.com

        1 Reply Last reply Reply Quote 0
        • T3P3Tonyundefined
          T3P3Tony administrators
          last edited by

          I should not edit documentation this tired from ERRF. Updated again, the image is actually correct this time.

          www.duet3d.com

          1 Reply Last reply Reply Quote 0
          • First post
            Last post
          Unless otherwise noted, all forum content is licensed under CC-BY-SA