Hello ,
here is my solution for the 6XD board
Best posts made by Zseven
-
RE: 24 volt fan with PWM control
Latest posts made by Zseven
-
6hc as expansion
Hello everyone,
is there a guide on how to use the Duet 6HC as an expansion board with the 6XD, and how can I configure it? -
RE: 24 volt fan with PWM control
Hello ,
here is my solution for the 6XD board -
RE: 24 volt fan with PWM control
ello ,
I have now got a replacement as the last fan has burnt out.DC7-24V brushless turbo fan motor 100000 rpm high speed aluminium alloy impeller with brushless motor and speed controller
I have now connected the fan direnkt to the 24V power supply and I can control it very well with the potentiometer
I have now measured the voltage at the potentiometer and between the red and black cable are 5V
The yellow cable should be the PWM signal.
How can I now control this fan with the Duet 6xd?
Witch pins ?
-
RE: 24 volt fan with PWM control
Hello ,
I have requested the data sheet from the manufacturer. -
RE: 24 volt fan with PWM control
Hello ,
I have
+24V at Out5 / V_OutLC1
-Out 5 / GND
PWM at Out 5 / out5-in config.g
M950 F2 C‘!out5’ Q1000
M106 P2 S0.0 H-1 C ‘Blower’ -
RE: 24 volt fan with PWM control
I have connected the fan and set the parameter Q1000. If I set the speed in the DWC to 95%, the motor burns out!
-
RE: 24 volt fan with PWM control
@Phaedrux Yes, I have read it but not understood it.
The fan has 3 pins 1x +24v 1x - 1x pwmWhich is the pwm output?
Outx-
Or outx.tach