Topics created by Zakm0n

@dc42 spot on. It does exactly what I expect with that removed.

And just as a verification if you have the berd air completely off the prints sill consistently complete without issue?

From: https://duet3d.dozuki.com/Wiki/SBC_Setup_for_Duet_3

Using a Pi4 may require a separate power supply for both the Duet and Pi4 due to power draw. The same holds true it using peripherals that draw power via USB.

@Zakm0n said in Need help with the nightmare that is cybersecurity.:

so can I just use a flash drive in the sbc and the panel to operate the printer?

see https://forum.duet3d.com/topic/20695/sd-card-1-doesn-t-panelue-sd-card?_=1611074040399

it does appear a flashdrive in the sbc should be usable from the web interface at least, but the developer doesn't specify if it'll also be available from the PanelDue

so try it? if it doesn't work you could try playing with userspace filesystems to overlay a flash drive (but suspect that'll have the same effect as what is described in that post) - or you could attach a hdmi/dsi based screen and run the web interface instead of the paneldue

@dc42 In the past with a different router, I had assigned an IP address to the duet on the router side, but never assigned a static ip on the board. AFAIK, nothing on my network uses a static IP, considering my subnet went from 10.0.0.x to 192.168.1.x on this new router, and I haven't had anything not connect to it. Should I maybe try a static IP?