Is there any downside to always show the tune babystep button on Paneldue?
If not, why do we purposely restrict that?
Paneldue shows current babystep while I’m tuning it, making it much easier to use than macro.
Is there any downside to always show the tune babystep button on Paneldue?
If not, why do we purposely restrict that?
Paneldue shows current babystep while I’m tuning it, making it much easier to use than macro.
Is there a way to tune babystep before print starts?
I can only do it on DWC. It would be much easier to use Paneldue.
Thank you!
M290 R0 S0 does not work with your save script, because the script changed G31.
This script is very useful!
It is possible to improve it, so the baby step can be reset?
To tune the babystep, I usually reset it to zero, home z, and insert a piece of paper under hotend. Be able to reset babystep to zero is important to me.
Hi,
Thanks lot of the photo. I’m doing the same project, and your post helps a lot.
Why do you choose not to connect the dual z stepper driver in serial configuration as suggested by the wiki?
https://duet3d.dozuki.com/Wiki/Wiring_and_hardware_differences_from_RAMPS_etc#Section_Stepper_motors