@deckingman thanks for all your knowledge and helpfulness on this forum!
I'm thinking of making a MMU2 type multi-material setup that's run via the duet and a duex5 so this thread has been super helpful!
I have a BMG that is currently set up as direct drive, and i would like to keep it where it is so that i have the excellent extrusion control that it gives me.
My question is: do both drives need to be set to the same steps/mm ?
the BMG is 3:1 and the mmu plans that I'm looking at are directly driven by hobs off the stepper shaft. can i set that up with m92 since (im assuming) I'll need to define the additional stepper as U or V axis
Thanks in advance!