@Phaedrux said in Duet 2 Wifi - Filament Sensor:
What firmware version are you running?
It won't show up as an endstop. It's a switch that is being monitored, but it's not an endstop in the normal sense.
If you start a print and then remove the filament from the switch does it stop the print?
FIRMWARE_NAME: RepRapFirmware for Duet 2 WiFi/Ethernet FIRMWARE_VERSION: 3.1.1
I did not test this for this moment. because i must first build the printer finish...
But you think thats "normal" and i had configured this right?
I am not sure because i found this here:
https://github.com/Duet3D/DuetWebControl/issues/189
