Best posts made by X3N07

@Phaedrux I found my mistake. I thought I had no start code for my extruder in cura. I even looked it up. But cura didn't display anything.

Turns out I did have one.
However, the start code was not displayed unless I clicked on the input box.

And in my startcode there were the bad gcode commands.

Now that I removed them, the gcode file looks normal again and everything works as it should.
So thanks

@dc42 I also let out the ( ) in my original config and that worked too. So that seems to be the real problem. Thank you

@oliof I used your config and now it works. So thanks