Posts made by WapuraRalf

@boa I have the same issues. I also have two sensors on a dual extruder. I understand that too little or too much movement is an issue to to stop the print. However the Sensor errors I saw until now are happening after a few hours but after resume the print runs fine for hours again. So why isn't there a way of ignoring those single errors and only trigger a stop if it is keeping reporting errors?

@phaedrux We know how to do that. I Even have the Trinamic experimental boards and Software. I thought that their might be people here that can share details of their conversions.

We read about former conversions of the CreatBot D600 pro to the Duett3D controller. We bought the Controller, the LCD and a Duex5 Extension Board. Now we do not plan to invent the wheel a second time. So hopefully we can get some further information how the former conversions were done. Does anyone know details like steps per millimeter on the axes and how the temperature sensors work with the Duet3D board. The hardware of the machine is basically ok, but we are fighting firmware bugs and CreatBot does not agree in the problems or share the firmware. Any help would be appreciated. We look forward to document our steps and share the approvements and STL files of parts we designed to improve this printer.

We bought the D600 Pro too and we are very disappointed. To make a long story short I just ordered the Duet2 WiFi and the 7” PanelDue. It would be great if you could share more details of your conversion. Do we have to order more components from Duet or is the printer Hardware easy to connect to the board? Any details would be appreciated.