Nevermind... I wired the 4x conductor connection wrong for the other tool board.
Best posts made by VoodooBane
-
RE: Homing Y moves the Z motors + 1LC are not connected not detectedposted in Firmware installation
-
RE: A BIG thanks to Duet3D for thinking of us "walking hazards"posted in Duet Hardware and wiring
It thought this link was amusing...lol https://duet3d.dozuki.com/Wiki/How_to_destroy_your_Duet_2
We take pride in out board and the way we designed it. Here is a sarcastic guide if you have the means to destroy out controller board made with our blood, sweat, and tears.... if you to try thanks for that.
WAIT can this FINE piece of engineering be overclocked?? I did just put that into the universe... my bad.
-
RE: RRF 3.4 Beta 7 | Tool-Offsets Issueposted in General Discussion
@jay_s_uk Ah yes will do. My mistake. Did mean to hijack anything..lol I will start a new thread. Sorry about that.
-
RE: Homing Y moves the Z motors + 1LC are not connected not detectedposted in Firmware installation
Update:
Turns out my Distro board was bad. I just replaced it. Everything is working as it should be now!
-
RE: RRF 3.4 Beta 7 | Tool-Offsets Issueposted in General Discussion
@sebkritikel I actually figured it out... lol I was doing a negative value on my T1 z-offset. But I changed, I got rid of the negative sign on the Z offset. it is working now. the layers are going down now.
Only wish I could use a fork of slic3r that allowed you to adjust the z-hop, z-retration, etc in the slicer itself instead of the firmware.