Good morning
Sorry and my classic English
I would like to build a hot wire machine to cut independent 5 axis polystyrol
2 X Motors
2 Y motors
1 Rotating Plate Z Motor
I tried various hardware solutions but was very impressed by the simplicity of the Duet with Touch display
The machine is very simple
I would like to use 2 independent Y axis motors with 1200mm travel, 2 independent X axis motors with 2000mm travel and finally a Z axis motor
Home and max area sensors For X-Y
Hot wire temperature control controlled by 12 - 48 volt voltage variator
My question is the following:
What kind of Hardware Duet can I use both Main and Tauch panel?
Which FW?
Which experimental setup for the listed features?
Thanks in advance for your advice

Good evening
I'm new to the forum, sorry and my classic English
I have a question for technical experts
I have a printer with Duet wifi + duex controller
Measurement of the printing surface 68 x 68 cm
I would like to partition the floor into 4 zones
How can I control 4 independent zones
The heating panels are 24 vdc pcb without thermistor
Thanks for your advice