@jay_s_uk ah, no. Those are values generated by RRF configurator, will adjust those values.
Best posts made by Tpmoses
-
RE: Compensation and calibration issuesposted in General Discussion
-
RE: Mini IR Z probe Nightmareposted in Duet Hardware and wiring
That was my mistake, Q1 is what was missing in both cases.
-
RE: Bed heater tuning questionsposted in Tuning and tweaking
@hamel The problem is time, this machine is used to make parts that are then used to make molds for fiberglass parts. A custom replacement wouldn't be here till May.... I already checked. Four smaller ones can be here by Monday. Ultimately its not my decision to make, bosses liked the faster option.
-
RE: Multi heater bedquestionsposted in Duet Hardware and wiring
Update, after talking to my boss, I'm switching the plan. We instead are going to go with four 1000W heaters, run them in two parallels with two separate 120V sources, and 2 SSRs with the same signal wire. That way the current draw wont be too much for the current breakers, and each of the heaters will get 120V.