Topics created by TheGov

@phaedrux Thanks for the fast reply fellows.

I replaced the files on the SD and flashed the 3.4 firmware via the PanelDue.
After that the Wifi adaptor no longer turned on, connected the Duet to my pc and turned on wifi adaptor by a command.
Connected through the COMM port and did the Wifi turn on command, all good now.

I can't find the 'Issue resolved button" here, but this topic can be marked as solved.
Cheers

@TheGov

If I had to design a brake for that Z axis I would mount the solenoid on that rail the motor is attached to and then have the Pawl on the left shaft . Design and print a Pawl cam and mate it to a GT2 20 or 30 tooth sprocket that has grub screws to fix it to the shaft and design and print an interference tooth for the end of the solenoid . Since its all plastic I would use surface areas as wide as possible . Its just a rough idea but I would attempt something like this

46116c52-0113-4910-b33a-d41e0f45e34e-image.png

those flanges for the GT pulley apparently are not that hard to take off and put back on again once that printed piece is fitted on

the e0 terminal seems crooked, can you check the soldering points at the bottom (with picture)