Topics created by thaug29

@oliof Thanks for your help but I'm going to stick with 3.4.6 for now and try to simplify and rewrite my macros at a latter time.

@thaug29 oops sorry, yes, io0.out, not io1.out.

Ian

@thaug29 It's easy to turn untwisted wire into twisted pair- just use an electric drill. It will take just a few seconds.

If your printer is working, you can make one of these:
https://drmrehorst.blogspot.com/2022/02/ultimate-3d-printed-wire-twister.html

@Phaedrux Sense I am color blind I can't tell what color the LED is and the issue happens so fast the flashing LED does not change as far as I can tell. I am using twisted wire with factory crimps on both ends which is soldered to the twisted wire. I have run a new wire and ordered a new ver1.3 board so one way or the other the problem will be fixed.

@thaug29
I think it means your printer now identifies as a toaster 🌈

Sorry, couldn't help myself.

Can you post your

config.g start.g homeall.g
*the first 100 lines or so of a print file

Use the </> button for each so as to make them easy to read.

@Phaedrux Ok, I have a new SD card with v3.4.4 on it and the printer is back running so I can now get back to my original problem. I will be running some test prints today to see if I have a bad thermistor or bad wire crimps or worn cables. Thanks

@fcwilt said in Error: unknown variable 'global.magprobestatus':

global magprobestatus = "unknown"

Thanks You, that did it!