Topics created by supermarioprof

@supermarioprof Done, going to mark as solved too.

Ian

@chrishamm ok thanks! I will have a look for DWC 2 indeed!

Hi
I did the automatic shutdown in a different, more universal way.
If got myself a smarthome power switch, a 'FRITZ!DECT 200'.
This switch cam be turned on or off by my AVM FritzBox. It can also be configured to turn off the power when the the connected device uses little or no power for a certain time.
I use it the following way: When about ready to print, I use my computer to turn on the power to my printer and start preheating the bed and extruder.
When the printing is done and the drawn power drops below 50W for more than 30min the power to the printer will automatically be turned off. The power and the time before shutdown can be adjusted.

@pedro-schmidt said in PNP inductive not properly working:

@bearer great stuff. i'm not stupid but i do like to see the diagram. its very clear now. thanks to everyone. i'll update you later on, hopefully with a successful install. cheers

no worries; people are different - i.e I've always preferred listening to reading/watching (and with Ian adding one to the wiki maybe the next guy finds it easier as well)

the most important part with those sensors are making sure it does what it says on the tin, especially if the lower end sensors from amazon/ebay/etc. incorrect marking/ colour coding or defective units do occur. luckily the duet with its 30v tolerant inputs are more rugged than most boards though.

will have a look, thanks! On monday I should receive my new heatsink so I will make a hole in the currently mounted one, and share here results!