Topics created by StAnZ-007

@oliof
Hi,

Thank for your information, I have check a lot of videos, tutos, and other CR-30 informations.
I will update the printer with NAK3D motors mount, allready ordered and a replacement Belt. It's same belt material seen on Ideaformer 3D Belt printers. So I hope better than the original one.
I see the linear rail kit from NAK3D, but it's expensive and not sure about quality for long time use, I will do same kind of kit by myself with HIWin linear rail.
For the nozzle system, I think I will try with the original at the bigging, and switch with orbiter system or similar after first custom step...

I'd be wary of including any commands that cause motion on startup without at least wrapping it in a M291 prompt that the user has to acknowledge.

Imagine a power loss and restore during a long print. Do you really want it automatically trying to probe the bed with a print still on it?

I solve the 2 problems now.

Heater tuning OK, and sensor pin was wrrong... My fault... 🙄

Thanks, Topic can be closed.

Hello,

Sorry if it's stupid question for you, but I'm not a electronic or software ingeneer...

I need to connect my relay to 1pin for signal and the second wire to ground, then I will have a signal for the relay ?
what will be the exit voltage ? 3.3, 5v or other voltage ?

Can I use every pin on the extension connector or only several pins are usable ?

Thanks for your help.

Bye.

OK, it's working when the "filament" folder is created in root, not in sys directory.

Thanks