I'm trying to sort out issues leveling the best on a daedalus 3d printer from Project R3d. From what I can tell it is mostly a RTP Railcore. It is a printer I inherited at work. It runs on a Duet3 board. Post is short because longer was not allowed by the forum.

The current heightmap shows a range from -2.989 to +2.080 mm. I've moved the print nozzle to the 4 corners as a test, and the deviation I find is only about 0.3 to 0.4 mm. I have ran G32 multiple times and the results never really get better, just different.

The current heightmap shows a range from -2.989 to +2.080 mm. I've moved the print nozzle to the 4 corners as a test, and the deviation I find is only about 0.3 to 0.4 mm. I have ran G32 multiple times and the results never really get better, just different.

I'm trying to sort out issues leveling the best on a daedalus 3d printer from Project R3d. From what I can tell it is mostly a RTP Railcore. It is a printer I inherited at work. It runs on a Duet3 board. Post is short because longer was not allowed by the forum.