@MaracMB I know this is an old post, but taking a chance, currently building a DQEX or IQEX. Very similar to this, a modified E5 Plus printer, is there a way of activating all 4 extruders and nozzles at once? Or will this be done from the slicers side? I have a Duet2 + Duex5 wired up, just need to set the Z limit switch, everything works so far. But the next step would be to slice a part on an appropriate slicer - Any suggestions on the slicer I should use?
I have been able to control all the part cooling fans and the hot end fans, as well as extruders. Interested in duplicate or mirror printing, nothing else, need high throughput.
Utilized the new config tool, and I think 3.5X firmware, was very cool to set it up.