Best posts made by skhotso

I have a duet wifi on my cr10 running the latest fw 2.04rc1. When I'm on my first layer and I click z babystepping up 0.05mm it does nothing. I've changed it all the way up to 3mm and the nozzle doesn't move up at all. Is there a trick to this in the DWC? I see the command being sent in the gcode console but zero movement.

While the printer is idle, I click the babystepping and it responds instantly. I know it may have to finish a layer before processing the babystepping command but it never responds, layer after layer.

@Phaedrux
Yep.. I forgot to try that troubleshooting step before posting. I just made the assumption that the red lead on the fan would go to vfan and black lead would go to fan-.
After your response, I was like duh. went to test it on the always on port and it didn't work, swapped pins and it worked.

this thread can be closed and deleted from existence.