Posts made by Simon 1

Hi group !
I try to make something, i powered my board with a 5vdc power supply so it stay always online, i put a trigger button to trigg the PS whit M80 command...
The thing is when the printer sleeping the paneldue stay ON...
I try to cut power of the screen with a relay who cut the 5v of the screen but when i powered for the first time the screen goes on an work but if i turn the printer off via M81 an turn it ON again the screen goes black... it is powered but i get a black screen ??? ... but if i touch it the boutton command work but i see nothing on screen !

If anyone knows a way to turn off the screen while leaving the controller powered, please give me the information.
that would be really appreciated
sorry for my english, i'm french speaking
thank you in advance for your advice....

@Simon-1 Thank's for the reply but i find a firmware who working, ... My first two tries with firmware 3.5 did not work I had a black screen and the second time the colors were weird so I tried version 3.4 which worked the first time but I had the problem with the buttons of the heating room which did not work...

So I decided to retry all the 3.5 firmwares and finally I found one that worked.
I'm just starting out and I'm not very knowledgeable in programming and I just migrated my printer to firmware 3.5.3 a few weeks ago!!

there is a good difference between version 2.5 and 3.5.3...

Currently I am trying to make a trigger to turn on the power supply and turn it off with the same trigger if it is already on...

The heat chamber is solve !!!

@Simon-1 said in Paneldue and heat chamber controle:

Does anyone know how to configure the heater in the heating chamber to be able to adjust the temperature on the paneldue?

When I try to enter a temperature, it immediately clears when I press set

Thank's for your help

By the way i have 2 different firmware version and the 3.5 work but the 3.4... the 3.5 work on my personal printer but
the one i made a mod is for the company where i work an the paneldue is in 3.4 but the controler is in 3.5.3 i wonder
if it because of that it not working ??? the problem is the paneldue i receive dont work with the 3.5 firmware the colors
are weird ! i dont try all the 3.4 version of firmware for the paneldue maybe there a version who working .... I have to
look for that ....

Does anyone know how to configure the heater in the heating chamber to be able to adjust the temperature on the paneldue?

When I try to enter a temperature, it immediately clears when I press set

Thank's for your help