Topics created by Silrocco

@gloomyandy Hi.

I just solved the issue. I noticed in Object Model that the Y endstop was not showing "highEnd" and "type" it was for the X, but it was triggering, but not home as mentioned. So I switched over to another io, io5 to io2 and that solved it!

![Fixed]8be09707-9ca7-45f9-9a41-ffe26ecc5f8d-image.png image url)

One more thing, I switched over to Normally Closed.

@o_lampe Yes, I know that. I had the motor removed from the extruder gear housing. What I meant is that I'm using M302 P1 and commanding "Extrude" from the GUI to monitor movement for testing.

@PaulHew

I managed to fix the issue! Yay!!

Went to the G-Code wiki and made the change by adding the pull up resistor to "C"^zprobe.in"".

"The pullup resistor on the Z probe input is disabled by default. Enable it by prefixing the input pin (C parameter) with the ^ character. Enable pullup resistor with ^ if using Duet 2, running RRF3, using the Z probe input pin, and the probe type is a switch or BLTouch."
-Source: https://duet3d.dozuki.com/Wiki/Gcode

This is my change:
; Z-Probe
M558 P9 C"^zprobe.in" H5 F120 T3000 ; BLTouch connected to Z probe IN pin, free up MOD pin
M950 S0 C"zprobe.mod" ; servo/gpio 0 is Z probe MOD pin
M280 P0 S10 ; send control signal to BLTouch through servo/gpio 0

I appreciate your help! Thank you.

@dc42 Hi, after relocation the BL-Touch and adding additional probing points seemed to do the trick. Thank you all for you help> @JamesM @grizewald

New pics...

Jumping solved! Did a new RepRap Config at RRF, there may have been a error in my part on the first RRF config.

Please closed this as solved.

Thanks.