Topics created by siladeniz

@siladeniz said in I want to use both hotend heater pins but i cant:

@jay_s_uk Also I want to ask another thing too, sometimes while I am homing the device it goes to the wrong way, even I didn't change anything on the config or I changed something unrelated to that(like heaters) it happens. what can it be the reason and can I fix it permanently?

Can you give more detail about the behaviour? which axis goes the wrong way and when? How far? Consistently, or randomly?

@Phaedrux okay I found the problem the gateway number was changed and I set it with m554

M350 X128 Y128 Z128:128:128 E128:128 I1 ; configure microstepping with interpolation M92 X1600 Y1600 Z12800:12800:12800 E3936:6400 ; steps per mm E1:800 E2:837 M566 X540 Y540 Z56:56:56 E480:480 ; maximum instantaneous speed changes mm/min M203 X10000 Y10000 Z1800:1800:1800 E15000:15000 ; maximum speeds (mm/s) M201 X2000 Y2000 Z100:100:100 E1000:3000 ; set accelerations (mm/s^2) M906 X1000 Y1000 Z800 E800 I50 ; set motor currents (mA) and idle %

You should remove the extra parameters from the Z axis. You only need to set the settings for the axis once rather than each motor.

example: Z100💯100 should be just Z100

Extruders are different and must be set for each extruder motor since they are independant.

thank you for all your responses. It is the fuse! Its melted.