Topics created by Sgt G 294

I have found that it's very hard to maintain connection to the Duet board via wifi network if the computer I am using has VPN switched on.

SOLVED - thank you

Please Excuse my english

Some tips:

Check filament flow rate is lower than the nozzle can handle . I have e3e Revo Micro and this page has useful:

https://e3d-online.com/pages/revo-nozzle-maximum-flow-rates

Try to put the spool over bearings to minimize the pull the spool makes to the sensor

Check the sensor wheel is clean and if don´t cleanit by removing the plastic stuck in it

Check the extruder is not loosing steps

Check the extruder e-steps is correctly calibrated (if you send 100mm to extrude (G1 E100, you measure exactly 100mm )