Best posts made by SetraX

@oliof I really thought about that... but makes no sense does it? I tell you why. Yesterday my desktop computer died and believe it or not, I took my new laptop and connected via wifi to my router at home and no disconnect issues anymore.

This leads me to the following. The network card must have had a glitch or the port on the switch which my desktop was connected. Strange thing about is that no other connection was showing problems, only those to the printer. I also connected via a desktop switch... no difference.

Anyways thanks for the engagement. I was so suprised that for such a long time it must have had to sit and wait and all of a sudden a major problem solved, without DUET2 interaction.

All the best

@sonderzug, hello I might say, but I did install it today as substitute to my "plasticbottle" and I just unplugged it and replugged it and it works... no changes in config, no wire issues. Swapout and continue working.

Just wanted to note that if somebody swaps a BL-Touch for Creality CR-Touch.

All the best.

@SetraX Well done !!! I screwed up with relative and absolute positioning.
M82 ... I figured out from some partfiles sets to absolute positioning
M83 ... sets the relative position as I need it ...SOLVED

@Phaedrux Well after "unbelieving" that stepper motors if they work do not have a problem I learned it the hard way. Two motors had a play (about 0.5° and almost 0.75°). This is unbelievable. I'm so reality checked now.

This issue must have occured as I crashed the bed quiet a few times that the inner structure of my motors did loosen and created a play and I could never get same results. Also the noise of the moving machine changed into a humming. Before it had some tingeling (like a screw loose somewhere-could not chase it down to the source).

Also I changed every component:
RODS - Rod joints
BLTOUCH - CRTOUCH
Electronics, Drivers, even I shorted all cables to the minimum
I changed the buildplate to get a more even one
I changed the hotend
I chanaged the extruder ( I do not regret this one - now LDO Orbiter V2)
Yes also I upgraded to linear Rails with carriages...
Changed the belts to steel enforced belts...
The number of nozzles I changed I stopped counting (crash or hard touch and change)

Anyway not much more to change left besides the motors
Now the printer spits out results .... I'm so happy

Still a few issues with automation - and multiprobe, but I will get to that later

All the best and thank you