Posts made by sdigs

Anyone having an issue with files not showing up in uploaded list after upgrading to current edge firmware and DWC. I have uploaded a couple of jobs with printing them and i can not find them in the list. This is the first time I have seen this. Running the 1.17RC3 and the 1.14-b4 DWC. Thought I would ask if anyone else is seeing this.

I was thinking of creating a macro to run the G28 then G29 command on my Duet for probing the bed. Then just add the load bed file to the output of my files with my slicer. This would allow me to rerun the probing routine when ever I thought I needed to without doing it in a program. What are some other ways of doing this that I have not thought of that may be better? How are you planning on implementing this feature?

I have a Duet 8.5 running on my custom built corexy. I have a prox that is powered from an always on fan that is pushing 24v. I have this signal connected with a voltage divider showing 3v at the signal pin. I have this connected to the probe port on pins ad14 and gnd. The Z probe works and stops the printer when I do a z home. I am using P1 in the M558 config file. When I run the mesh, it moves my z axis but not alot. The mean after a 41 point probe is 0 and a deviation of .16. I know this is wrong, but don't understand why this is not working. I have tried to change the P1 to a P5, but the probe value on the Panel duet shows P1000 and never changes. If I activate the probe, it still shows nothing. I do have the always on fan running on the supply voltage to the probe. I am going to remove this tonight to see if this changes anything. Any ideas or thoughts will be appreciated.

sdigs