@engikeneer Ok cancel that phase problem. I moved the connection to drive 3 on the duet. Appears driver 3 is associated with drive 3

@engikeneer Ok cancel that phase problem. I moved the connection to drive 3 on the duet. Appears driver 3 is associated with drive 3

@engikeneer Picture didnt go through but it says "Warning motor phase a may be disconnected reported by driver 3"

And another warning for phase b

 @engikeneer Ok that works thanks. Now I gotta see why Im getting the warning in the next screen shot. Looks like bad wiring or output. I have the extension board. Can I reassign an output on the extension board to test my wiring?

I get a warning that says attempting to extrude with no tool selected.

Extruder is plugged into "Drive 4" or "E1 Motor" on Duet wifi board

@Phaedrux Ordered the part

@dc42 said in Thermistor daughterboard beginner question.:

If you send the M305 P3 X201 command from the console, does it respond with an error message?
What is the response if you send M305 P3 X200?

If you send the M305 P3 X201 command from the console, does it respond with an error message?
No

What is the response if you send M305 P3 X200?
M305 P3 X200
Error: Failed to initialise RTD: bad response from sensor

@Phaedrux With the wire, or a 100 ohm resistor, or simply with the "daughterboard" removed I get the same result.......2000 and fault

@Phaedrux  

@davidvh86 Is there anything you want me to post to clear up any confusion?