Connected the Duet to the computer. Thanks for the support provided
Best posts made by SANJR
-
RE: Connecting Newly Configured Duet MB 6HCposted in Duet Web Control
-
RE: Bed Levelling Using 3 Independent Z Motorsposted in General Discussion
@Phaedrux Thanks
I would start testing the motors movement very soon, after that i would test the G30 as well.
-
RE: New Cartesean Machine Stepper Motor Testingposted in Tuning and tweaking
@Phaedrux Hi,
The X Axis Stepper Motor is being tested when the Emergency Push Button is pressed.
The Y And Z Axis Motor were working fine after the EPB usage.
Since the Other Axes were having multiple motors i was not able to test them with X Axis driver.
However after a brief time with a shutdown and restart the X Axis was working fine.
-
RE: Using G Codes to Test the Motor and Relayposted in Tuning and tweaking
@jay_s_uk Thanks for the update provided
-
RE: MCU & Stepper motor drivers temperatute sensor configurationposted in Tuning and tweaking
Thanks
The last line for the drivers of expansion board M307 G-Code is used is this correct? Should i replace it with the M308.
In the documentation it is mentioned as M307. But on referrring the G-Code M307 is to set the heater process parameters.....