Posts made by sandmaker

I managed to fix the printer, It had deleted it's config file and I was able to find the original file for it to replace it. Thanks for the help guys.

I'm able to connect to the printer web interface but I'm unable to mess with the axis's, it's returning the error failed to enable endstops.

@Phaedrux After Downloading YAT and sending M122 I got the response, Emergency Stop! Reset the controller to continue.
followed by ok.
I didn't originally set the duet board up so I'm not sure how to reset the "controller"
I'll look into it but I'm sure you may know what that means.

I'll try both of these suggestions out and get back to you guys.

I checked the router logs as well it's still the same ip address that I had before the print failed.

Hello, I have a 400x400 ratrig v3 with a Duet 3 mainboard 6HC. I was running a print and had left it to run at night and when I had gotten back in the morning the printer had failed the print and I was unable to connect to the web interface via the ip address. (There are activity lights on the board and a flashing red light) A week before this failure we had moved it from one room in our office to another. I'm not particularly tech savvy with this printer or the instructions as I didn't set it up. I also tried to contact ratrig and they said that Duet would be able to help but they wouldn't be able to do anything. Any help would be appreciated.