Thank you both for your help. I misunderstood what a core xyu is. My printer is a supposed to just be a core xy with an additional axis for the tool change mechanism. (my printer is most similar to E3D's tool changer 3D printer.)
Best posts made by SamKudarauskas
-
RE: Y axis moving significantly slower than X axis
-
RE: BL-touch probe already triggered at start of homing move.
@Phaedrux The white wire must have came loose at the start of the day and then I must've replugged it into the wrong pin spot. I believe I connected the BL touch's white wire into +3.3 V instead of IN when I was checking the wires. I noticed this, fixed it and it works fine now. thankfully it didn't break anything.
-
RE: Incompatible Software Versions
@droftarts I was able to flash the firmware using Bossa on a windows partition of my macbook. Everything now works as it should. Thank you all of your help.
Sam