Posts made by Ronald25w

Problem is solved after a pid tuning. Hopefully it doesn't come back

Hi all,

Heater 1 fault: heater monitor 0 was triggered is the error I get. I don't know what causes this.
Already erased the whole mainboard and updated the firmware. But still the same problem. As soon as the desired temperature has been reached the error pops up.

Anyone knows how to solve this ?

Hi all,

This weekend I ran into some problems with my duet 2 wifi. The problems where that my PanelDue 4.3 freezed when I was doing a 2 color print that needed to be paused to change the filament. The printer paused just like it normally did but my paneldue was freezed so i couldn't hit resume also webcontrol was not available due some kind of wifi issue. After that I tried another 2 color print to see if the problem came back and it did. I thought maybe it's something firmware related so I did a firmware upgrade to 3.1.1. I thought that would solve the problem and it did. But another problem occurred. The problem caused my printer to freeze at the start of a print or mid print when I opened webcontrol on my tablet. To solve that problem I removed find my duet from my tablet.

My question to you all did any of you ran into a similar problem and knows how to solve it.

kind regards,

Ronald Wiekken

Thanks this solved my problem

Thanks I will do a test with it hopefully it is solved

I use Cura 4.0 with creawesome mod

Hello everybody,

I have my CR-10S setup with a duet 2 WIFI but I am running into some issues. The quality of the prints is great, but my printer runs at very low speed. I have read a lot of topics about it and made some changes in the config.g file but still no progress. Also, there is a weird noise on the Z axis when the printer runs at that very low speed. I don’t know what to do at the moment so I am asking you what could cause this weird behavior. I made some videos about the behavior and a voice recording.
Through this link https://drive.google.com/open?id=1nMvOG0Egpb-0P1nwaSZzZATdG4cEPzge

You can access the files.

I hope somebody can help me.

Hello everyone,

I have question. I am doing a hardware change. I am going to setup a duet wifi to my cr-10s. Does somebody already have a good working config file and would like to share it?

Thanks

Hello everyone,

I have question. I am doing a hardware change. I am going to setup a duet wifi to my cr-10s. Does somebody already have a good working config file and would like to share it?

Thanks