Hi,

Where in Europe do I find highend GT2 belts online?
What do I need to look for in a belt?

Please move this post if its in the wrong category.

@DIY-O-Sphere
I did and from what I can see there is no error in it.

Pause retracts -10 and resume prime with 10. but what happens is that when resume runs it does two prime cycles.

This is a bit strange because I have not changes any thing in these files.

I did a test and set resume to prime 5mm and that created no blobs and due to it priming two times it was totally fine results to the resume with no blobs.

I cant figure out why it does two primes on the resume.

Hi, need som help to understand what I screwed up...

My printer is a direct drive and now when I resume from a pause it ejects ta big blob in two extruder pulses. Cant say if I did screw up in simplify 3D or in configuration.. Any suggestions to what controls this is appriciated..

Now I got back to previous state and can connect to wifi but nowI get a warning on DWC.
Error in start-up file macro line 17: use M552 to abandon the current connection attempt before using this command

How do I address this?

Hi

Got an error saying I needed to clear with m552 S0 so I did that.
Now I cant get it on wifi with my old m587, what do I need to do?
Here is my m587 and the static IP I like to have..
M587 S"xx" P"xx" I10.0.0.45 J10.0.0.1 K255.255.255.0 ; Network config

@arnold_r_clark
Thanks Arnold, really appreciate the help.

What kind of config did you guys use for the filafarm pad termistor?

@arnold_r_clark
You’re right, it was cut short inside the sleeve. Thank every one for the pointers.

@arnold_r_clark
Thanks for the info. Just need to figure out the one wire termistor to get going.

Hi

Im about to rebuild my bed with a filabase bed from filafarm.

Its a 230v silicon pad and it comes with a SSR.
My old was a 24v bed.

Do I run same 24v Duet wifi output to control my SSR?
It seems as the termistor in my pad is a single wire 100k termistor, where on the Duet should I connect it?

Going to ground my frame and put in a ground breaker too.

All good now with both changes, thank you