Whatever you get, I'd recommend the Delta Smart Effector big time. Its probably smarter than me but I could still understand it for to say
Best posts made by Ricky_Grade10
-
RE: Delta printer recommendation with Duet2
-
RE: Stop Thermal Transfer from Bed to Frame
As you guys know, I only got my grade 10 but my thinking thoughts are saying that if the heat transfers to the frame then could it be possible for the frame to experience thermal expansion on some level or another and then obviously it could be for to say that the frame might flex or mess with the calibration?
-
RE: Need advice on new heated bed aluminium plate
If your in the US, try these guys...
https://www.midweststeelsupply.com/store/castaluminumplateatp5
Latest posts made by Ricky_Grade10
-
RE: Need advice on new heated bed aluminium plate
@fcwilt Both my deltas, Orangie and Mr. Pink, use 1/4 inch tooling plate from them and both plates arrived quickly and have been awesome
-
RE: Need advice on new heated bed aluminium plate
If your in the US, try these guys...
https://www.midweststeelsupply.com/store/castaluminumplateatp5
-
RE: Delta printer recommendation with Duet2
Whatever you get, I'd recommend the Delta Smart Effector big time. Its probably smarter than me but I could still understand it for to say
-
RE: Need advice on new heated bed aluminium plate
I know some of you are aware of these plates...
Has anyone here used one of these plates before?
Im thinking about thinking of building a new printer and I think Im going to go corexy. I'd really like to use a bed like that so as not to deal with all the.. pardon my italian... bed adhesivion fuckery
-
RE: Stop Thermal Transfer from Bed to Frame
As you guys know, I only got my grade 10 but my thinking thoughts are saying that if the heat transfers to the frame then could it be possible for the frame to experience thermal expansion on some level or another and then obviously it could be for to say that the frame might flex or mess with the calibration?
-
RE: MRRF 2019?
Any ideas on who will be there for to say on Duet3D's behalves?
-
RE: Tool to remove heater pins from the Black connector
Is this the correct tool for removal?
https://www.digikey.com/products/en?mpart=11-03-0043&v=900
Site says its 22 and some change. I know I only got my grade ten, but thats not that bad when you think about having to buy a new connector, crimp terminal metal thingy and a new fan when they go out. I made my own by taking a small screwdriver to a grinder.....
-
RE: Retraction Tuning Guide
So if the R value is positive, it will unretract more and act like a primer of sorts? Im guessing I should start with a small value for this parameter?
-
RE: Retraction Tuning Guide
So if the R value is neglative does that mean it will retract the filament even more?
I guess Im having problems trying to figure out the order of the retraction process.
In my brain compartments, I have been thinking it would retract first, then z hop and finally un-retract. Is that the way she goes?
-
Heater fault trouble
Alright boys, I'm getting a heater fault shortly after starting a print. I can autotune it fine and bring it up to temp, no big deal. But when I run a print, I get a fault after it starts. Is there one of those light things on the board to tell me when the hotend is working like the heat bed?