Best posts made by rhol1964

@dc42 That is probably true, however, I bought this board in Feb 2021 from Filastruder, and am just now getting around to setting it up. I think I may have misplaced the card that came in the slot, so I used the configuration tool online to generate the files and put them on a blank sd card, and installed it in the slot. Now I am able to successfully get the wifi module working and was able to connect to the board using DWC. Now it's just all the minutia of configuration and possibly I can try a test print this weekend. Thanks, everyone for the prompt help.

I think I figured out my problem. The tool was configured to control both fans. So I removed fan0 from that. Second the Q value was so low the fans would not turn unless at 100%. Setting this value to 65000, allowed the fans to work at all values. I think I am good now

@Phaedrux Yes I tested the outer pins on both of those connectors and they were both 47.1K Ohms. But I think I found the issue, when removing the X plug from the board, one wire pulled out of the connector but the pin remained in the connector. The wire was broken clean, I removed the pin and found a good crimp, it just broke off right through the insulation and the wire. Makes me wonder if these original Creality wires are at all trustworthy now, might purge these old wires from my setup. And on a good note, I was finally able to print an XYZ block!