Not sure what I did but I finally got this thing connected and running via DWC. I'd say it had to do with the USB 3.0 or probably if I had a powered hub like others have mentioned.
Best posts made by resh
-
RE: Duet 2 wifi - Can't connect via USBposted in Firmware installation
-
RE: Endstops not working during homeing but light up on boardposted in Duet Hardware and wiring
Fixed the directions by changing S1 to S0 in config for P0 and P1.
-
RE: Need help with Y axis re-designposted in 3D Printing General Chat
@fcwilt When you get time I would appreciate it. Safe travels
-
RE: What is this connector?posted in General Discussion
@fcwilt said in What is this connector?:
Those items are called ferrules.
Here is the crimper:
You can buy sets of the ferrules on Amazon as well.
Frederick
Thank you, Frederick. Just what I needed, another tool
-
RE: Duex5 error when powering onposted in Duet Hardware and wiring
@phaedrux There's no damage to the chips or surrounding area.
Got it used off ebay. I'll send it back.
I appreciate the help.
-
RE: Duex5 fan voltageposted in Duet Hardware and wiring
Found the jumper and everything is working properly. I really appreciate everyone's help and patience with me.