@dc42 Thank you for the amazingly quick response! The firmware binary fixed the kinematic issue.
Still lots of tuning and tweaking to do but the kinematics seem to be working correctly now.
Here's a short video showing what polar's do best, printing vases: https://drive.google.com/open?id=1T2Wjb3OejqWlkfOUjZREdYk8xY59UvRD
@fcwilt My homing files are the same as outlined in the polar setup guide: https://duet3d.dozuki.com/Wiki/ConfiguringRepRapFirmwarePolarPrinter
@dc42 Thank you for the amazingly quick response! The firmware binary fixed the kinematic issue.
Still lots of tuning and tweaking to do but the kinematics seem to be working correctly now.
Here's a short video showing what polar's do best, printing vases: https://drive.google.com/open?id=1T2Wjb3OejqWlkfOUjZREdYk8xY59UvRD
@fcwilt My homing files are the same as outlined in the polar setup guide: https://duet3d.dozuki.com/Wiki/ConfiguringRepRapFirmwarePolarPrinter
Hi all,
I’ve setup a polar printer on the Creality CR-10 just as a learning experience.
Following the guide outlined (https://duet3d.dozuki.com/Wiki/ConfiguringRepRapFirmwarePolarPrinter) I’ve been able to get it up and running. An issue that I am running into is that if the polar axis rotates over a certain angular position then the print stops for about 10s before resuming and continuing the print. I am unable to confirm if this is at the angular position 0/2pi rad, however, this would seem like the most plausible position. This pause occurs rotating in either direction and also during travel moves.
This video shows the pause during a printing move: https://drive.google.com/open?id=13Qj13-Mbc08P1ego272jXPiLEMTOrbtV
This video shows the pause during a travel: https://drive.google.com/open?id=1O9Eta8F2TTrEmmupU9bnrWBSLBsu7jKQ
If the print does not need to rotate through this position, then everything works as expected.
I am using a Maestro 2 with Firmware 2.02(RTOS) (2018-12-24b1). This is my polar config:
Is this an issue in the firmware or is there something wrong in the setup?
Martin