Topics created by Recoil

I found the solution "M558 P8 C"^!zprobe.in" R0.4 H5 F300 X0 Y0 Z0" That did it 🙂

Hi T3P3Tony,
l already read both of them, what was weird is that after following instructions setting the Z offset it wouldn't take as I mention I had to Disable Mesh Grid Compensation to make it work and I do not know why, I would have thought it sets correctly every time I run it.

Found my mistake, it was a syntax mistake looking at the command I realize I entered twice the "S" parameter, the first instance was getting applied duh!

Hi Veti,
It is working now! I do not know exactly what did it since I did everything you suggested, removed first line, added the space and upgraded the FW to 2.04RC1.
Anyhow I thank you for your help 🙂

After a lot of hair pulling I think I got the board working on the bench, however I am unsure what fixed it since I been trying everything I could think off. I did check the guide that Phaedrux suggested I did notice that in /sys there where missing files ... config.json, sleep.g, stop.g, tfree0.g, tpost0.g and tpre0.g. I did generated a new config file downloaded and replaced the /sys. However I was still seeing disconnection to DWC, changed to 1.22.6 from 1.21 once more thereafter I was still experiencing drops every so often. I deleted all saved WiFi's with M588 S"*", re-added my AP with M587 S"networkname" P"password" and finally reset it again with M552 S0 and re-enabled it with M552 S1. cleared cache in my browser and tried again so far so good 🙂
Thank you all for your help!