5
4
7
17
19
Latest posts made by Reanimator2k
-
RE: Duet WiFi firmware new feature priorities
Possible in principle, but to do it accurately I think it would need two linear CCD sensors and probably lenses. Unless you are extruding your own filament, it's probably not worth while IMO because most filament has good diameter accuracy these days.
Yes, i want to use my own filament(From Filastruder 2) and yes, you get my bad English right, dual CCD sensors is what i want. Not a must have thing, but i think it will increase quality of my prints and make my printer more userfriendly.
I saw this, not my thing, i want dual sensor because filament may have an oval profile.
-
RE: Duet WiFi firmware new feature priorities
G. Support for three independently-controlled Z motors, normally moved in sync but moved independently when performing bed leveling (and I really do mean bed levelling, not bed compensation).
I just want to thank you for this being in a new feature list.
And i have a question if this is a proper thread. Is it possible to do a two side filament diameter measurement with live adjusting printing parameters depending on filament diameter?