Topics created by Rat_Patrol

Sweet. Thanks!

@Rat_Patrol said in Build and store multiple MESH profiles?:

I run the maximum number of data points I can, so it takes about 30 minutes or so to run the full bed probe sequence.

Another feature that may address this problem is being able to mesh before every print, just in the printed area. This will give very accurate mesh result in a very short time since most prints are much smaller than the bed area.

Any thoughts?

Looks like the same error I have, I will check the probe offset right now.

It is working properly now, thanks!!!

@Veti
Sweet.

I'll be working on the conversion over the next week or so, will post back if I have any questions!

Thanks all!