@printnoob And another problem I encountered, one of the Z motors isnt running smooth. When switching the pins on the mainboard, the other motor is the one stuttering, so its because of the board or the firmware

I am really struggling with it right now... The x-Axis homes on the right side, which isn good because the superpinda is then out of the printplate and doesnt stop the printhead... and when Im heating the print bed I get an error, which says that the temperature needs to rise 2.3 degrees per second but it only does 0.3 so its defect, how do i change that value of 2.3 degree?
Could somebody please give me his WHOLE mk3s config files?

@Proschi78 Im having a duet 2 wifi, can I just take his config.g and paste it into mine, or is the gcode betweend the Duet 3 Mini different?

I set up my mk3s with the reprap firmware, but Im a bit struggling with the sensorless homing and the setup of the super pinda... can sbdy of you other prusa users share your config files with me? That would be pretty awesome

@Phaedrux it all worked now, but now Im not sure how I do set up the sensorless homing?

@Phaedrux Thank you very much

Hello guys.
I got my first 3d printer - a used prusa with an installed Duet 2 wifi with ?klipper? on it, Im not quite sure, there was no card in it. Now - dumb as I am, I thougth i could just go to the reprap tool, create the firmware, put it on the card and boom the mainboard works, like I knew it from Raspis but as I saw then, the webmonitor didnt show up under the ip described in the duet firmware blog entry. Now I believe, I have to totally flash the board, but I dont find any good explanation for this? Sometimes its just "press the erase button" then sometimes "short these pins" and sometimes both. Then another question is, do I need to undo all the cables from the mainboard whilst flashing? Could somebody please share a stp by step guide for dummys on "How to flash reprap-firmware onto the Duet 2 wifi"
btw sorry for my bad english, its obviously not my mother tongue

This is the file structure I created with the reprap configurator, I included the wifi credentials already there, so no need to install bossa, right? ...right?

( image url)

@weed2all Hi, thank you weed2all, I read a bit through the guide you linked. I will totally do it, when the prinnter arrives, that looks really convenient to use. If Im having any questions in setting it up, for example if I dont know what to choose in the configurator, can I ask you then? For example, for the motors and endstop page, because Im not truly sure, how I do it with the superpinda and sensorless homing. But thats music from music of the future, it has to be delivered for that.
Thank you for posting the link and sending me on my reprap journey

Hello all!
Im in a dilemma right now - I inherited a mk3 with a duet 2 wifi and klipper installed. It didnt arrived to me right now, but a good research starts early I read through the internet and saw, that for the use of klipper there is a raspi needed, fortunately I own one. I do wonder now, what do I have to install on the pi? This is the first 3d printer I own and Im a bit overwhelmed right now another option would be to reinstall the old rambo einsy board, but only if there is not much rewiring needed, because its as i stated my first 3d printer... well, some advices beforehand would be nice, but Ill write again when the bad boy arrives.
ty