Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
undefined
I'm curious as to why you'd want to mesh bed before heating. Doesn't heating potentially warp the bed? I always let my printer sit at bed temp for awhile before I mesh so that it has a chance to stabilize.
Hello, I'm having this same issue with the White Knight belt printer.. Was a solution ever determined?
@phaedrux said in Auto Bed Leveling Map on Tronxy X5SA:
@pr0xyfl00d3r said in Auto Bed Leveling Map on Tronxy X5SA: i have added Z Baby Stepping Current Offset: 0.2 mm and seems to be ok, i think i can see a slight bubble to the sheet on the bed If you find a consistent amount of baby stepping that you need you can add it to the G31 Z value to make it permanent. Has the height map image improved at all? Is the first layer going down better?
@pr0xyfl00d3r said in Auto Bed Leveling Map on Tronxy X5SA:
i have added Z Baby Stepping Current Offset: 0.2 mm and seems to be ok, i think i can see a slight bubble to the sheet on the bed
If you find a consistent amount of baby stepping that you need you can add it to the G31 Z value to make it permanent.
Has the height map image improved at all? Is the first layer going down better?
Yes the map has flatten by half ish..
