I've had this board for months now and my printer remains dead because I can't figure this out. Just like the title says I don't get it. I've had this board so long it makes me sick to my stomach every time I think about starting to figure this out again. I'm not stupid. I'd still be using marlin if it weren't for so many freaking bugs. Sure just ue the configurator, easy right? NO it's not easy at all when there's no definitions and no guidance on it.
Page 3 I/O mapping No expansion boards configured. drive x driver x endstop pin xstop Ok, what is that?? and once again I'm stuck, pissed off, feeling like an idiot wishiing I never would have fallen for the hype of this really expensive board that just sits and collects dust.
I know I'm not the only one. Why can't you guys just make this easy? you haven't made enough money on these things yet to have a decent set of instructions made up?? WTF? 
