Thank you I think that will help,
Pegaso
Posts made by Pegaso
-
RE: I want to build in" Duet 2D Wifi " into a Anycubic Predator.posted in Firmware installation
-
I want to build in" Duet 2D Wifi " into a Anycubic Predator.posted in Firmware installation
Hello,
what are the correct values, for the stepper-motors if I want to use 256 microsteps on the "Anycubic Predator" (X,Y,Z and E0)?
The values in the original Firmware are 0,0125 for X,Y,Z and 0,00256 for the E0.
Can I use 1 / 0,0125 and 1 / 0,00256, are the values with 256 microsteps the same?
The preset for that values in that config-asistand on Page two are 80 for XYZ and 4000 for E0.How can I find the correct settings, to fill in this page and the following.
Thanks in advance for your help.
Pegaso