@novaprint you propably had stealthchop on, so just turn it on again

Yeah, I get that, but I dont get how to enter it as a 16bit integer into the T part

@jacotheron oh, actually you are right, I should use the non mini file then, because I report a lot of problems with DWC2 to @chrishamm

@novaprint you propably had stealthchop on, so just turn it on again

@dc42 I read it a lot of times but I still don't know how to configure it

I got it to happen, if I run M701 S"PLA" I get this problem

Hi, I want to configure Coolstep on my HEVO, but I do not know what to include in the M915 gcode, the wiki is not too helpful

@dc42 for some reason I am unable to replicate the issue now

@dc42
G90
G1 X60 Y-20 F4000
M291 P"Ready?" S2
G1 E40 F1400
G1 E80 F300
M291 P"Filament byl úspěšně zaveden!" R"Výměna filamentu dokončena" S1

@jim would you mind sharing the progress? I maybe could help a little bit

Hi, I have a load filament macro and it heats up, parks and asks for confirmation to start loading, but this does not wait and starts extruding infinitely until I confirm it and it does the gcode one more time and then stops and errors with Error: Push() stack overflow. RRF2.02