Ah perfect yea that fixed the issue with the screen stuck on connecting.
I have to head to bed for work tomorrow but I'm very glad to have most issues fixed.
Thanks a ton Jay, i'll be sure to ask you for any other help I need.
Ah perfect yea that fixed the issue with the screen stuck on connecting.
I have to head to bed for work tomorrow but I'm very glad to have most issues fixed.
Thanks a ton Jay, i'll be sure to ask you for any other help I need.
I don't. What exactly is it that I would need to replace on the mobo? Sorry I'm still new to working on 3-d printers.
Here is the X-axis trying to home after being plugged into motor drive 3 on the mobo and being remapped in the config.g
Is that indicative of a blown drive motor on the mobo?
What specifically would I change in my config.g to change that?
@phaedrux it was the pancake motor for the extruded assembly. So I ordered an entire new assembly with new motor and the new one is doing the same non spinning issue which means it must do with the firmware change. Maybe the motor is mapped wrong or the amps. I’m not sure
There is a video of me performing 1 10mm extrude and 1 10mm retract. This is with the brand new extruder motor and assembly. I had no issues whatsoever before updating my firmware. You can see it not really spinning and just sort of grinding
@stephen6309 so I had bought a new motor completely and was trying last night to get it working and it was making a loud noise any time I tried to retract or extrude just like the previous one. Everything worked perfectly fine before the firmware updates I did so I’m sure it has something to do with the amps or something along those lines. I can take a video today if that helps
Hello,
I updated my firmware on my Vivedino Troodon Corexy 400x400x500 to the latest 3.4b6 and after sorting out most of the issues I went to print and everything was looking good except the extruder was making a noise and then started smoking after about 4 minutes. I shut it off immediately and have been adjusting the M906 and other relevant code and bought a new extruder since the old one seems seized. I did a test extrude with the new one and it just shakes and the gears don't spin? I'm not sure what to adjust in the config file. Please let me know what the issue is. Here is my Config file config (2).g
Ah perfect yea that fixed the issue with the screen stuck on connecting.
I have to head to bed for work tomorrow but I'm very glad to have most issues fixed.
Thanks a ton Jay, i'll be sure to ask you for any other help I need.
This is the fan error
M98 P"0:/macros/Preheat/preheat_PLA"
Error: Fan number 3 not found
Ok yea i'll have to work on swapping over everything to adjust for my bed size, thank you so much. Any ideas as to why the print screen is stuck on connecting now though?
@oscorp and the printer screen is stuck on connecting, even after trying to swap baud rate so I can only control it through the Wi-Fi connection