Posts made by nodashi

If my sd card died im going to have to reconfigure the firmware from scratch. Is there anyway to easily backup the firmware or the config files so if the sd card dies i can load the firmware and be up and running again? Thanks also is there a easy way of figuring out how much storage is left on the sd card? thanks.

Im sorry if this has been asked already but, Im looking to change the locations of auto bed leveling. Not the bed mesh grid but just the 4 points it probes before you can do mesh grid leveling. The carriage hits the end of the extrusion when leveling the right side because the bltouch is so far to the left. I've been able to compensate for it in the mesh grid leveling, but i have no idea how you do it on the g29 command. thanks

Looks like i blew the fet on the fan 2. https://imgur.com/a/2aRFj6S anyone know what the part number is and if its the only thing that would blow? I accidentally shorted the pins.

ok new update i was able to get it to work , but now im back to the same problem of no sd card. I think its the SD card mount thing. Im not sure what to look for or which pin it is, but im fairly sure its the sd card mount

ok for some reason the board works now but i have this problem still. When i access the the system editor in the web interface i get a message saying "The current volume is not mounted"

M21: No SD card present<LF>ok<LF> seems the board is not reading the sd card i've tried 3 different ones

When I type in m503 I get: M503: Configuration file not found<LF>ok<LF>

I bought the duet used thats why it didnt have a sd card. So i upload the files from the github you linked and replaced the files in the sys folder with the ones from the configurator and connected the board to the wifi using this guide duet wiki however when i go to the IP Im prompted with this error message "Your Duet rejected the HTTP request: page not found" What am i doing wrong?
Edit: I've also tried using a new sd card

So I just got my duet wifi second hand and it didnt come with a sd card. I got the board to connect to wifi, but when i enter the address in my browser nothing comes up. I think its because the SD card is emply and it needs the correct files. However I dont know what files it needs and which it doesnt. I used the configurator and have config files ready. However Im not sure what else i need. I read some tutorials but it had older what i presume out of date files on it and im not sure if i should follow it. Thanks for the help.