Topics created by nico.rast

@droftarts Thanks!

@droftarts said in VORON 2.4 A/B STEPPER PROBLEMS:
Hi Ian,
thanks for the response. I didn't notice that there are two steps for the Z axis; one should have been Z and the other E. As for the motors, I currently had these at home and tried them out. I started with a current of 1A and increased it gradually for testing, and it ended up at 2A. Anyway, I will replace them soon with NEMA17 SUPER POWER (42STH48-2804AH). I'll try lowering the speed settings and see if anything moves. The command I sent was always G91 G1 H2 X10 F3000 G90, but I just copied the G1 part, etc.

Thanks
Nico

@droftarts Thanks, i'll try !!!

Have a good day 🙂

Nico

@Exerqtor Do you find it more difficult to communicate with a different board than the Duet? Or does it remain simple with the CAN bus and just a matter of assigning some addresses?
I didn't know that Annex was stepping out of the open-source project. If I see that it doesn't work well, I'll get the ERCF. Even though I've already built the trad-rack. My real issue is that there aren't many configurations for RRF, and I'm not very skilled in 'free' programming. I like to experiment, but I don't have any studies that could help me. 🙂

@gloomyandy didn't see 😞
I m going to order a couple of RJ11.

Thanks

@nico-rast you can use the 3hc

@droftarts, @fcwilt

guys really thanks. Can i offer u guys a coffee?

See you!

thanks again!!! 🙂

@oliof
Thanks man IT WORKS!!!!