Ok, Thanks!

Hi! Im using 2 cat 5e cables for all wiring to the x carriage. But now i realize this solution ends up with one wire to little.
So the question is, can i wire something with common ground/ vcc?
The functions needed is:
heater 4 wires (using 4 wires for more area)
termistor 2 wires
hotend cooler 2 wires (on when >60c)
part cooler 2 wires
stepper motor 4 wires
capacitive sensor 3 wires.
17 total

The cat 5e has 8 cable giving me 16 total.
It must be possible to wire the fans to common ground/ vcc?
Any other suggestions?

Thanks!

It's a Ultimaker style printer. I have measured it to about 0.1mm x and 0.15mm y. I have seen a lot of discussion about removing mechanical fault, but its really the same as bed leveling and square up xy axis. It can be done to a great length mechanically and it should. But having the possibility to dial in the last bit in firmware helps a lot!
Other firmware's does it already, look at this as a example : http://www.thingiverse.com/thing:2040624
Thanks!

Hi! Does anyone know if there is a backlash compensation function in firmware? Some thing like the M99: Set axis_hysteresis_mm command. With the M556: Axis compensation and auto bed level this firmware is really powerful but i feel that the backlash compensation is missing?

Thanks!