@droftarts Sounds good. Let me know how you make out!

@droftarts I am using just the 4-wire and everything is working fine. Not sure why I had both connections in use, I must have miss read something when I was building this printer years ago. The 10 pin was 130cm long.
Any way sorry for the trouble and thanks again for the help!
Mike

@droftarts I don't see anything that looks like it could be shorting. Firmware is 3.5.0-rc9-v3-7.0 and I have both the ribbon and 4-wire connected.

@Phaedrux I found the problem. When the Panel Due 7 is plugged in it will not recognize the accelerometer

@Phaedrux With everything unplugged it is recognized on both boards. I guess I'll start plugging things back.

@Phaedrux Same thing with the update. If I just unplug everything from the board in place, this should give the same result as on the bench correct?

@Phaedrux No I haven't done the update. I will do this before I put it on the bench

@droftarts Hello I received a new accelerometer. Unfortunately I'm having the same issue. Could it be the Duet 2 board? Everything else seems to work with the board though.

@droftarts Looks like I bought it at Spool3d on Oct.20/23, but just getting to install it now...lol. Probably not worth the effort for warranty, for the cost of a new one.

@droftarts Thanks Ian, I really appreciate your help with this.
Thanks again! Mike