@MartinNYHC Take a look at this kit.
https://www.alibaba.com/product-detail/GIULY-All-Metal-BLV-mgn-Cube_62451669742.html?spm=a2700.icbuShop.81298.1.77a7737ch3D3qc

@Phaedrux Sorry long work days. I unplugged the BLTouch on both side and plugged it back in. Hard reset and now it is working. Sorry it took so long to get back to you guys.

During printing my SBC says randomly "Network error, not connected" Then shuts down the print I have running. Not sure what is causing this.

@fcwilt makes perfect sense. I will set that. Thank You

@phaedrux
I will make that change.
Thank you

@phaedrux
6hc

@phaedrux
G31 P50 X16.795 Y25.4 Z.43
Tried P8 and P5
VCC DO AO are the three wires Red, Black, Blue in that order
I put them on the board Red to 5v Black to Ground Blue to In.
My assumption is the potentiometer changes the how sensitive
it is.

@mrenz999
Also, m119 gives this respons.
m119
Endstops - X: not stopped, Y: not stopped, Z: not stopped, Z probe: not stopped

@mrenz999
I guess I should mention firmware 3.4b7

I am using this probe I have as a backup. Other one broke and waiting for a replacement to come.
https://www.amazon.com/dp/B07V6GR72Q/ref=cm_sw_em_r_mt_dp_o8r7Fb4BMTP14

Duet 3 mainboard. Connected to io 3. Hot is connected to the 5v pin, Blue wire is connected to the In pin, black connected to ground.
M558 P5 C"io3.in" H5 F300 T6000

I have tried with an exclamation point in front of it and without. It shows at 1000 with the exclamation point and zero without. When I
tap it either way no changes or acknowledgement of that happening.
Where am I going wrong ?
lol

Thanks

@gloomyandy Will do. My heaters just turned off mid print. So no board reset.

@vrghost I had a similar issue. Did not reboot just stopped printing twice now. Once 3 mins in the second time 6 mins in. I checked on printer both times to find the heaters off, bed and tool, and it stopped. No errors reported just not printing.

@fcwilt I will answer for me. No, my issue was never resolved.

@fcwilt makes perfect sense. I will set that. Thank You