You left me no choice! Ordered! 
Best posts made by monster
-
RE: Seeking an advise on what Z sensor to go withposted in IR Height Sensor
-
RE: G-code magic for advanced homing?posted in Gcode meta commands
@littlehobbyshop
Version:
Board: Duet 3 MB6HC (MB6HC)
DSF Version: 1.2.4.0
Firmware: RepRapFirmware for Duet 3 MB6HC v0.6 or 1.0 3.0 (2020-01-03b3)@bot
That axis gets unhomed I did figure out. That is sad.
But hey, how come both parts of IF are executed - that is quite a feature
I tested it now with messages (which aren't working correctly them-self) and with sounds. Seems like IF is out of scope
I guess what is left is what you said "tell the toolhead to go to the X10 Y10 position at the beginning of the homing script."
But then again once home requested it might be invalidated by unhoming all. I need to test it... -
RE: How to calculate feed rate?posted in Tuning and tweaking
@deckingman Thank you a lot for this portion of knowledge. I'm slowly processing it
I guess after re-reading it 10th time I'll get it right @giostark amazing link. Thank you for that lifehack
